Re: Moen bath tub spigot and shower head? - moen shower heads
Hello,
We have a problem in our bathroom. We are working on renovating our bathroom and is close to the final after it in brick and through the wall of the tub. The problem is that when the faucet to fill the bathtub, but out of the shower and faucet. If you lower the pressure (ie the amount of water through), let the faucet.
We have tried:
a. We believe that the cut was small, so that screws and let the same thing happened
b. The tube an inch wide, to see the cock, whether this would reduce the pressure back ... The same thing happened
c. Decreased flow of water in the bathtub to the rejection of the shock absorbers ...., If you half the water pressure at the valve outlet. But it would take too long to fill the tub.
d. Find the problem in a new cartridge in the same controller ...
We never had this problem before. Our recent shower wa
Monday, December 21, 2009
Moen Shower Heads Re: Moen Bath Tub Spigot And Shower Head?
1 comment:
sounds like the diversion of water out of alignment. In general, diversion of water by gravity, a process is controlled. When you open the front derailleur to the force of gravity pushes the water along the path of least resistance, filling the tub conversion spout.closing essentially caps the feeding tube, forcing the water from the shower pipe. Make sure the head is aligned properly diverted. Some models have a button on the filler neck, while other models are a series of three valves. an outlet for hot water, one for the cold, and this means the valve is diverter.if happens, the valve was not installed correctly when it is removed for remodeling.otherwise easy failing.they easy to repair or replace, but the right pieces can be found tricky.a Center Home Improvement lead, it is necessary or the parties and a Vendor can happily find them.es Hope this helps Plumbing and helpful!
Post a Comment